Install Openwrt On X86 Pc Serial Images Have

But there are also existing very small low power industrial embedded PC plattforms e.g.

PC-Engines APU, Alix or WRAP or Soekris boards.

You might have to change it a little, if youre booting off something else.

Install Openwrt On X86 Pc Serial Images Have

Default IP is 192.168.1.1 username: root password: admin Current serial images have a console port setting of 115200,8,n,1.

Depending on the environment, you could login as root, use su or sudo.

WARNING: A mistake in the of target of the command could wipe out other discs on your system.

Use command dir to list directory contents and verify that both files are there.

BE VERY CAREFUL WITH NEXT STEP Next you will select drive to apply the image to.

This will overwrite all contents on drive ususally your main drive is drive 0 and if you do not have another drive other than the dd-wrt drive then it should be drive 1.

Install drive into dd-wrt machine, connect NIC to another computer or to LAN.

Boot dd-wrt computer and after it says that eth0 is up then use other computer to configure remotely.

Default ip is 192.168.1.1 so make sure you set your computer to the same subnet i.e 192.168.1.5.

Open browser and type 192.168.1.1 into the location bar and the control panel for dd-wrt x86 should come up.

If this is a registered install then you will then take the System Key displayed and enter it into the activations center at dd-wrt.com.